Why is office Wi-Fi often poor?
- One router for everything. The internet provider's Wi-Fi router often sits in a corner or the comms room. Walls, ceilings and glass weaken the signal, and distant rooms barely get anything.
- Extenders and repeaters. They increase range but often cost a lot of speed, because they use the same radio link twice.
- Crowded channels. The 2.4 GHz band has only a few channels that don't overlap. Where many neighbouring networks are on air, they interfere with each other.
- Too many devices. Laptops, mobiles, printers, cameras and phones all share the same access points.
- Old devices and firmware. Outdated routers slow things down and, without updates, are a security risk.
What makes professional Wi-Fi?
Several access points instead of one router
In a business, several access points on the ceiling or wall provide the Wi-Fi – spread out so that every room is well covered. They are connected to the switch by network cable and draw their power over it too (PoE). A cabled connection is more stable and faster than a pure radio link between the devices (mesh).
One network name for the whole building
All access points broadcast the same network name. Devices automatically switch to the nearest access point as you move around, ideally without interruption – important for calls and video meetings over Wi-Fi.
The right frequencies
The 2.4 GHz band has a long range but is often congested. The 5 GHz band offers far more channels and speed with a slightly shorter range. Newer devices with Wi-Fi 6E or Wi-Fi 7 can also use the 6 GHz band, which is still hardly occupied. A well-configured network steers capable devices onto the faster bands.
Planning instead of trial and error
More transmit power is not automatically better: access points that are too strong interfere with each other, and devices cling to the wrong access point for too long. What matters is the number, position and configuration of the devices. That's why we measure coverage on site before we install anything.
How do I make the Wi-Fi secure?
- Use WPA3 – or mixed WPA2 and WPA3 as long as older devices are in use.
- A separate guest Wi-Fi, kept apart from the company network. Guests get internet access, but not access to your data.
- A separate network for devices such as printers, cameras, phones or smart home components. That way an insecure device can't put the whole network at risk.
- Strong passwords and WPS switched off.
- Regular updates for access points, switches and the firewall.
Which hardware do we use?
We work mainly with UniFi by Ubiquiti and with Cisco. UniFi offers a lot of performance at a fair price and can be managed centrally; we use Cisco where requirements are special. On top of that come suitable PoE switches and a firewall.
How a Wi-Fi project works with us
- Site visit and measurement: we check the rooms, the building structure and the existing network, and measure coverage.
- Planning: number and locations of access points, cabling, and networks for guests and devices.
- Installation and setup: access points, switches and firewall, properly documented.
- Check: after installation we measure again and fine-tune the settings.
- Support: updates and monitoring so the Wi-Fi stays reliable.
Do you make calls over Wi-Fi? Then have a look at our guide VoIP for SMEs. Find out more about our network services under Network & Infrastructure.